Let StrongPoles make it easy to install your electrical devices with our camera mounting platforms. Our Junction Boxes and Mounting Platforms are used for more than just cameras. The front faces on these platforms are large enough for devices like equipment cabinets, power supplies, transmitters, and antennas.
This 8″ x 8″ x 10″ Bolt-On Mounting Platform, also known by our Dealers as “The Birdhouse,” has been used in many different ways, but is designed to provide four long, broad mounting faces for large devices. These mounting platforms are constructed out of 3/16″ aluminum, and 3 of the faces have pre-drilled 1.362″ holes for wiring access that will accommodate any 1″ conduit fitting, wire gland, or liquid-tight fitting. The fourth face does not have a pre-drilled hole because this face is commonly used to mount large power supplies boxes or equipment cabinets. The aluminum can be drilled quickly to accommodate any size access holes you may need. On top of the birdhouse, there is a pyramid cap that can be removed for easy access inside to make the connections for the wiring harness.
This handy bolt-on 6″x6″x4″ Junction Box can be used in many different ways. It can be used merely as a junction box to give installers more room to make connections for electrical devices like camera surge protectors, small POE injectors. The outside faces can be used to mount IR illuminators, directional antennas, or small-footprint cameras. The junction box is constructed from 1/8″ aluminum, so it is quick and easy to drill your access holes or any bolts or screws holes that you need for mounting. On all four faces, there are access holes pre-drilled to the size of 1.125″ that any 3/4″ conduit fitting, wire gland, or liquid tight-fitting can be installed. On top of the junction box, there is a pyramid cap that can be removed for easy access inside to make the connections for the wiring harness.